Group-Based Snmp Access; Licensing Requirements For Snmp; Guidelines And Limitations For Snmp; Default Snmp Settings - Cisco Nexus 3548 series Configuration Manual

Configuring SNMP

Group-Based SNMP Access

Note Because a group is a standard SNMP term used industry-wide, roles are referred to as groups in this SNMP
section.
SNMP access rights are organized by groups. Each group in SNMP is similar to a role through the CLI. Each
group is defined with three accesses: read access, write access, and notification access. Each access can be
enabled or disabled within each group.
You can begin communicating with the agent once your username is created, your roles are set up by your
administrator, and you are added to the roles.

Licensing Requirements for SNMP

This feature does not require a license. Any feature not included in a license package is bundled with the Cisco
NX-OS system images and is provided at no extra charge to you. For a complete explanation of the Cisco
NX-OS licensing scheme, see the Cisco NX-OS Licensing Guide.

Guidelines and Limitations for SNMP

Cisco NX-OS supports read-only access to Ethernet MIBs.
For more information about supported MIBs, see the following URL:
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml
Cisco NX-OS does not support the SNMPv3 noAuthNoPriv security level.

Default SNMP Settings

Table 19: Default SNMP Parameters
Parameters
license notifications
linkUp/Down notification type
Default
Enabled
ietf-extended
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 7.x
Group-Based SNMP Access
95