Starting The System - Samsung OfficeServ 7100 Installation Manual

8.2 Starting the System

The procedure for starting the OfficeServ 7100 system is as follows:
1) Check if the boards and cables are properly mounted and connected to the OfficeServ
7100 cabinet.
2) Turn on the power of the OfficeServ 7100 basic cabinet, and turn on the power of the
expansion cabinet.
3) Check the LEDs for the MP10/11 boards mounted on the OfficeServ 7100 cabinet.
The RUN LED of the MP10/11 board turns green and the MC LED flashes when
the system normally starts the booting process.
Once the booting is complete, the RUN LED of the MP10/11 board flashes green,
and the SM LED stops flashing and remains lighted.
The RUN LED of the LCP board flashes when the power supply and processor
status of the expansion rack is normal.
If the Multi Media(MMC Card) is not detected
If the system cannot detect the multi media, the MC LED of the MP10/11 board flash
in red. In such cases, remove MMC card from MP10/11 boards and insert it again.
4) Check if the LED statuses of other interface boards are normal.
5) If the LED status of a MP10/11 or interface board is abnormal, turn off the power of
the cabinet and turn the power on again.
Board LED Status & Shut-down
- Refer to the 'OfficeServ 7100 System Manual' for LED statuses of each board.
- Shut-down is hardly required while operating the OfficeServ 7100 system.
© SAMSUNG Electronics Co., Ltd.
However, when shutting down the system due to reasons such as moving the
system, turn off the power of the expansion cabinet, and turn off the power of
the basic cabinet.
OfficeServ 7100 Installation Manual
8-3