Mounting Interface Boards; Setting Switches And Mounting Optional Boards; Table 3.6 Interface Boards That Can Mount Option Boards - Samsung OfficeServ 7100 Installation Manual

CHAPTER 3. Ошибка! Стиль не определен.

3.3 Mounting Interface Boards

This section describes how to set jumpers and switches of an interface board, how to mount
optional boards to an interface board, and how to mount interface boards into slots.

3.3.1 Setting Switches and Mounting Optional Boards

These interface boards are divided into the boards to set switches or jumpers and the boards
to mount option boards.
Interface Board
TEPRI
TEPRI2
TEPRI(a/2) Cards is only support E1(1) PRI function, but not supports for
E1(T1) Digital Trunk function.
Interface Board
MP10(MP11)
UNI
4SWM Module board supports not 10M LAN interface but 100M LAN interface.
4TRM Module board supports not Dial Pulse dialing but DTMF dialing. 8TRK
Card supports DTMF and Dial Pulse dialing
3-6
Table 3.5 Interface Board for Switches/Jumper Setting
Jumper/Switch Setting
S1(SW1~SW8)
S2(1~4)
S3(1~4)

Table 3.6 Interface Boards that can mount option boards

Jumper/Switch Function
Setting E1, T1/E1/PRI, 24B+D/24B,
User/Network and 17H/13H
Setting T1, E1, T1/E1,PRI, 24B+D/24B,
User/Network and 1AH
Option Board
4DLM or 4SWM, MODEM
4TRM, 2BRM, 4DLM, 4SLM
© SAMSUNG Electronics Co., Ltd.