Assembly
2.4.
Assembly
1. Remove the two M6x20 and four M5x15 Socket Head Cap Screws
that secure the motor covers in place and place them in a safe
place for reuse later when the covers are re-installed (Figure 2-10).
Figure 2-10. Motor Cover Outer Screws
M6x20 Socket
Head Cap Screws
(4X)
2. Remove the smaller Forward Covers as shown above (Figure 2-
10).
3. On both sides: Remove both inside 4mm screws as shown in
Figure 2-11 and place them in a safe place for reuse later when the
covers are re-installed.
Installation
M5x15 Socket
Head Cap Screws
(2X)
Forward Cover
(2X)
13