Mounting The Pci Board Into The Pull Out Aid - Fujitsu PRIMERGY RX300 S3 Operating Manual

Hot-plug PCI Boards
8.4.1

Mounting the PCI board into the pull out aid

Before installing the PCI board, it must be mounted into the pull out aid:
1
2
Figure 31: Mounting the PCI board into the pull out aid
Ê Press the two green snap-fits down completely (1) and remove it from the
guidances (2).
Ê Place the PCI board into the slot of the pull out aid (3).
Ê Carefully press down the green snap-fits (4) until the PCI board is fixed.
Do not jam the board.
94
1
2
3
Operating manual
Hot-plug Components
4
4
RX300 S3