Fujitsu PRIMERGY RX300 S3 Operating Manual page 91

Hot-plug Components
Ê You should read the accompanying documentation supplied with the board
beforehand.
I
Only PCI boards of the same type and with the same settings may be
exchanged. If the boards do not match, the new board will not be
commissioned.
Ê Remove the housing cover (see
page 95).
Ê If necessary, start the PCI hot-plug software (PCI Card HotReplace). You will
find operating instructions in the file "README for the PCI Hot Plug Software
V3.0" on the ServerStart DVD.
Ê Deactivate the board using the relevant PCI hot-plug software or by pressing
the button (a) (see
The power indicator for the hot-plug PCI slot (see
flashes green. The slot is in the disable sequence.
Ê Wait until the power indicator changes its status (not lighting). The slot is now
powered off.
RX300 S3
section "Opening/Closing the Housing" on
figure 30 on page
Operating manual
Hot-plug PCI Boards
92).
table 5 on page 56)
91