Fujitsu PRIMERGY RX300 S3 Operating Manual page 56

Operating and Indicator Elements
Indicators on hot-plug PCI slots
The indicators on these slots behave differently depending on whether
or not (table 6 on page
Power
indicator indicator
(6)/(green) (5)/(orange)
does not does not
light
flashing does not
lights does not
does not
light
Table 5: Operating system with hot-plug functionality: hot-plug PCI indicator modes
56
57) the operating system supports hot-plug functionality:
Error
1. Device switched off.
light
2. Device operating but PCI slot not powered up.
One board may be installed or removed.
Device operating.
light
PCI slot is in enable or disable sequence.
Wait until the green LED has changed its status
(does not light after disable or lights after enable
sequence).
Device operating.
light
PCI slot powered up. No board may be installed or
removed.
lights Device operating: a problem has occurred.
There are two possible causes for this status:
– The MRL sensor was pressed without authori-
zation. This status cannot be exited (NMI
initiated: see
Indicator Lighting" on page
– There was a power failure during the enable
sequence (the PCI slot is reset to disable
status).
Operating manual
Preparation for Use and Operation
Status description
section "Hot-Plug PCI Error
72).
(table 5)
RX300 S3