Table of Contents
Advertisement
DEC LSI 11
The following program sends a command string to the
Model 595 from a DEC LSI 11 minicomputer and displays
the instrument reading string on the DEC CRT terminal. The
LSI 11 must be configured with 16K words of RAM and an
IBV 11 IEEE-488 interface. The software must be configured
with the IB software as well as FORTRAN and the RT 11
operating system.
DIRECTIONS
1. Using the front panel program feature, set the primary
2. With the power off, connect the Model 5 9 5 to the IBV
3.
Enter the program below, using the editor under RT 11
4. Compile using the FORTRAN compiler as follows: FOR-
5. Link with the system and IB libraries as follows: LINK
6.Type RUN IEEE and press the RETURN key.
7.The display will read "ENTER ADDRESS'.
8.Type in 9 and press the RETURN key.
9.The display will read "TEST SETUP".
address of the Model 595 to 28.
11 IEEE-488 interface cable.
and the name IEEE.FOR.
TRAN IEEE.
IEEE,IBLIB.
10. Type in the desired command string and press the
RETURN key. For example, to program the instrument
for the current function and
2004
range, type in FlR8X
and press RETURN.
11. The instrument data string will appear on the computer
display. A typical display is: NIVX+0.59500E-12,
+oo.ooo.
61
Advertisement
Table of Contents
