Table of Contents
Advertisement
APPLE II
(APPLE II IEEE-488 INTERFACE)
The following program sends a command string to the
Model 595 from an Apple II computer and displays the in-
strument reading string on the computer
CRI.
The computer must be equipped with the Apple I 1 IEEE-488
Interface installed in slot
3.
DIRE(=TIONS
1 . With the power off, connect the Model 595 to the
IEEE-488 interface installed in the Apple II computer.
2. Using the front panel program feature, set the primary
address of the Model 595 to 28.
3 .
Enter the lines in the program below, using the RETURN
key after each line.
4. Run the program and type in the desired command string
at the command prompt. For example, to place the in-
strument in the current function and 200pA range, type
in FlR8X and press the return key.
5. The instrument reading string will then appear on the
CRT. A typical display is: NIVX+0.59500E-4. +OO.OOO.
53
Advertisement
Table of Contents
