Advertisement
CHANGING AND SETTING THE FUNCTIONING MODE
When the lock comes out of the factory, it is set to function in mode 1. To
change the functioning mode, you must:
access the "programming" facility
p
A. with the door open, press the spring latch
it pressed, then bring the "master" TAG close to the receiver located on
the external plaque
1
B. the acoustic alarm will emit a scale of rising sounds to tell you that the
lock is in the "programming" mode.
The lock will only remain in programming mode as long as you keep
the spring latch pressed. If you release the spring latch, you will auto-
matically leave the programming mode.
C. so, while keeping the spring latch
press press the green key located on the internal plaque
least one second to modify the functioning mode. The buzzer emits a
number of short sounds (beeps) that corresponds to the operating mode.
D. Each time the green key is pressed you move on to the next mode.
For example: If when the green key is pushed the buzzer emits three short
sounds (three beeps), this means that the lock is in mode 3, in which case,
to change to mode 5, simply press the green key twice.
NOTE:
the functioning mode can only be changed by increasing it, i.e., from 1 to
2, from 2 to 3 and so on. After mode 5, you can return to mode 1 by press-
ing button green again.
release the pressure on the spring latch
P
HOW IT WORKS
with one finger and keep
5
(fig. 1).
constantly pressed all the time, now
5
to exit the programming mode.
5
(fig 6) for at
2
FIG.1
FIG.6
9
Advertisement
