Advertisement
MANAGING THE TAG KEYS
The electronics used by the FIAM x1R locks enables you to manage all the TAG
used simply, rapidly and in complete security.
You can deactivate and reactivate the "service" TAG , also temporarily, add
or remove TAG from the list in use or cancel all of them.
To deactivate ALL the "service" TAG , you must:
access the "programming" facility
p
A. with the door open, press the spring latch
it pressed, then bring the transponder registered as the "master TAG "
close to the receiver located on the external plaque
B. the acoustic alarm will emit a scale of rising sounds to tell you that the
lock is in the "programming" mode.
the lock will only remain in programming mode as long as you keep
the spring latch pressed. If you release the spring latch, you will auto-
matically leave the programming mode.
C. so, while keeping the spring latch
now press the black button located on the internal plaque
for at least one second so that the buzzer emits 1 short tone (1 beep).
Warning: All the "service" TAGS are now disabled for opening the lock,
but are still stored in the electronic memory.
This operation simultaneously disables all the "service" numerical
codes as well and all the radio-controls in use.
release the pressure on the spring latch
P
To reactivate ALL the "service" TAG , you must:
access the "programming" facility
p
A. with the door open, press the spring latch
it pressed, then bring the transponder registered as the "master TAG "
close to the receiver located on the external plaque
B. the acoustic alarm will emit a scale of rising sounds to tell you that the
lock is in the "programming" mode.
The lock will only remain in programming mode as long as you keep
the spring latch pressed. If you release the spring latch, you will auto-
matically leave the programming mode.
C. so, while keeping the spring latch
now press the black button located on the internal plaque
at least one second so that the buzzer emits 2 short tones (2 beeps).
All the "service" TAGS in the electronic memory have now been re-en-
abled to open the lock
This operation simultaneously re-enables all the "service" numerical
codes as well and all the radio-controls in use.
release the pressure on the spring latch
P
BASIC PROGRAMMING
with one finger and keep
5
(fig. 1).
1
constantly pressed all the time,
5
to exit the programming mode.
5
with one finger and keep
5
(fig. 1).
1
constantly pressed all the time,
5
to exit the programming mode.
5
(fig. 3)
2
(fig 3) ) for
2
FIG.1
FIG.3
10
Advertisement
