Advertisement
Together with the TAG and keyboard entrance controls your door with its
FIAM x 1R electronic lock can also be controlled by a x. Radio
trol system, where provided.
ACTIVATING RADIO CONTROL
access the "programming" facility
p
A. with the door open, keep your finger pressed on spring latch
place the TAG or "master" numeric code near to the receiver located
on the external plaque
B. The acoustic alarm will emit a rising scale of beeps to warn you that the
lock is in the "programming" mode.
The lock will only remain in this mode (programming) for as long as
you keep the spring latch pressed. You will automatically leave the pro-
gramming mode by releasing it.
C. Keep pressing the spring latch
nal plaque
(fig. 3) for at least one second. The buzzer will emit one
2
short beep. Then press key 6.1 on the radio control
dio control presented and activated with the procedure just described
will be recorded at "service" level. The buzzer will confirm memorizing
each radio control with one a short beep. When you have completed
the memorization procedure go on to enabling all the radio controls
recorded at "service" level, by pressing the black key on the internal
plaque
(fig. 3) for at least one second. The buzzer will emit two short
2
beeps.
NOTE:
If the buzzer emits TWO short beeps at the start of stage 3 then press the
black key again until the buzzer emits ONE short beep only, confirming that
the lock is now set for memorizing the radio controls at "service" level.
release the pressure on the spring latch
P
6.3
RADIO CONTROL SYSTEM
BASIC PROGRAMMING
(fig. 1).
1
and press the black key on the inter-
5
to exit the programming mode.
5
6.2
6.1
radio con-
6
and
5
(fig. 9). Each ra-
6
FIG.1
FIG.3
FIG.9
21
Advertisement
