Download Print this page

FIAM. x1R User Manual page 11

Electronic lock for security doors

Advertisement

To definitively cancel ONE or MORE transponder TAG , you must:
access the "programming" facility
p
A. with the door open, press the spring latch
it pressed, then bring the transponder registered as the "master TAG "
close to the receiver located on the external plaque
B. the acoustic alarm will emit a scale of rising sounds to tell you that the
lock is in the "programming" mode.
The lock will only remain in programming mode as long as you keep
the spring latch pressed. If you release the spring latch, you will auto-
matically leave the programming mode.
C. so, while keeping the spring latch
bring the TAG keys to be cancelled close to the reader located on the
external plaque
(fig. 1), one at a time. Each time a TAG
1
from the memory list, the buzzer will confirm by emitting 3 short tones
(3 beeps).
release the pressure on the spring latch
P
To definitively cancel ALL the TAG keys (complete reset), you must:
access the "programming" facility
p
A. with the door open, press the spring latch
it pressed, then bring the transponder registered as the "master TAG "
close to the receiver located on the external plaque
B. the acoustic alarm will emit a scale of rising sounds to tell you that the
lock is in the "programming" mode.
The lock will only remain in programming mode as long as you keep
the spring latch pressed. If you release the spring latch, you will auto-
matically leave the programming mode.
C. so, while keeping the spring latch
now press green and black buttons located on the internal plaque
2) at the same time for at least two seconds. The acoustic alarm will emit
one long tone to confirm.
This operation simultaneously deletes all the numerical codes as
well and all the radio-controls in use.
release the pressure on the spring latch
P
BASIC PROGRAMMING
with one finger and keep
5
(fig. 1).
1
constantly pressed all the time,
5
to exit the programming mode.
5
with one finger and keep
5
(fig. 1).
1
constantly pressed all the time,
5
to exit the programming mode.
5
is cancelled
4
(fig.
2
FIG.1
FIG.2
11

Advertisement

loading