Advertisement
ACTIVATING THE TAG "MASTER KEY":
access the "programming" facility
p
A. with the door open, press the spring latch
it pressed, then bring any TAG (of those supplied) close to the receiver
located on the external plaque
B. the acoustic alarm will emit a scale of rising sounds to tell you that the
lock is in the "programming" mode.
The lock will only remain in programming mode as long as you keep
the spring latch pressed. If you release the spring latch, you will auto-
matically leave the programming mode.
C. so, while keeping the spring latch
press the black and green buttons located on the internal plaque
(fig. 2) at the same time and keep them pressed for at least two sec-
onds. The acoustic alarm will emit one long tone to confirm.
D. now chose any of the TAG x.Keys supplied and bring it close to the receiver
located on the external plaque
tones to confirm programming of the TAG as the "master key".
release the pressure on the spring latch
P
ACTIVATING THE "SERVICE" TAGS:
access the "programming" facility
p
A. With the door open, hold spring latch
bring the TAG programmed before at a "master" level near the receiv-
er on the external plaque
B. the acoustic alarm will emit a scale of rising sounds to tell you that the
lock is in the "programming" mode.
The lock will only remain in programming mode as long as you keep
the spring latch pressed. If you release the spring latch, you will auto-
matically leave the programming mode.
C. so, while keeping the spring latch
now press the black button located on the internal plaque
and keep it pressed for at least one second: the buzzer emits just one short
tone (1 beep). Every TAG that you bring close to the receiver (fig. 1) will
be registered at the "service" level. The buzzer confirms programming
of each TAG by means of a short sound (1 beep). Once the program-
ming phase has been completed, proceed to enabling all the TAGs pro-
grammed at a "service" level, by holding down for at least one second
the black button on internal plaque
brief sounds (2 beeps).
NOTE:
If at the start of phase C the buzzer emits TWO short sounds (2 beeps) press
the black key again so that the buzzer only emits ONE short sound (1
beep), confirming that the lock is now set up for programming new "ser-
vice" TAGS
release the pressure on the spring latch
P
BASIC PROGRAMMING
, with one finger and keep
5
(fig. 1).
1
, constantly pressed all the time, now
5
. The acoustic alarm will emit two short
1
to exit the programming mode.
5
down with one finger and
5
(fig. 1).
1
constantly pressed all the time,
5
(fig. 3). The buzzer emits two
2
to exit the programming mode.
5
2
(fig. 3).
2
FIG.1
FIG.2
FIG.3
6
Advertisement
