Advertisement
NOTE:
The decision as to who will be responsible for the master code and service
codes is entirely a question of the hierarchy one intends to activate. Con-
sidering that the master code, as already mentioned, apart from being nor-
mally used to open the door, can also be used for access to any program-
ming level, it should evidently be kept and used by the person responsible
for the premises.
We would also remind you that the master code can also temporarily exclude
one or more of the service codes, but this cannot be done the other way
round. As an explicative example, in a typical family the responsible mem-
ber of the household can assign a service code to a domestic worker.
If you want to prevent said person from entering while you are away, you
just have to disable the use of the service code used by the latter from the
electronic memory; this mean that it will be deactivated even though still in
their hands.
When you return you can re-enable the code, where necessary (see page 18).
ACTIVATING OTHER "MASTER CODES":
access the "programming" facility
p
A. with the door open, keep your finger pressed on spring latch
the "master" code on the keyboard,
B. the acoustic alarm will emit a rising scale of beeps to warn you that the lock
is in the "programming" mode.
The lock will only remain in this mode (programming) for as long as
you keep the spring latch pressed. You will automatically leave the pro-
gramming mode by releasing it.
C. Keeping the spring latch
ed on the internal plaque
will emit two short beeps.
NOTE:
If the buzzer emits one beep only, press the black key again until the buzzer
emits TWO short beeps confirming that the lock is now set for memorizing
new "master" codes.
D. digit the numeric code, minimum four and maximum eight figures (fig.
10) and after confirmation press the # key. The code just memorized will
then be registered at "master" level. Any other code entered in the same
way will also be registered at "master" level, while this status is active or
until the spring latch
5
release the pressure on the spring latch
P
BASIC PROGRAMMING
followed by the # key (fig. 10).
1A
constantly pressed, press the black key locat-
5
(fig. 3) for at least one second. The buzzer
2
has been released.
to exit the programming mode.
5
and press
5
FIG.10
FIG.3
15
Advertisement
