Advertisement
CHANGING AND SETTING THE FUNCTIONAL MODE
The lock is set to work in mode 1 when it comes out of the factory. To
change the functional mode, it will be necessary to:
access the "programming" facility
p
A. with the door open, keep your finger pressed on spring latch
press the "master" code on the keyboard
10).
B. the acoustic alarm will emit a rising scale of beeps, to warn you that the
lock is in the "programming" mode.
The lock will only remain in this mode (programming) for as long as
you keep the spring latch pressed. You will automatically leave the pro-
gramming mode by releasing it.
C. Keeping the spring latch
cated on the internal plaque
buzzer will emit the same number of short beeps as the number of the
mode being used.
D. Each time you press the green key you will pass on to the next mode.
For example: if the buzzer emits three short beeps when you press the
green key, this means that the lock is in mode 3, in which case, you sim-
ply press the green key twice if you want to to change to mode 5.
NOTE:
the functional mode can only be changed going up the scale, i.e., from 1
to 2, from 2 to 3 and so on. After mode 5, you go back to mode 1 by
pressing the green button again.
release the pressure on the spring latch
P
BASIC PROGRAMMING
followed by the # key (fig.
1A
constantly pressed, press the green key lo-
5
(fig. 6) for at least one second. The
2
to exit the programming mode.
5
and
5
FIG.10
FIG.6
17
Advertisement
