HIKVISION DS-7716NI-I4/16P Quick Start Manual page 3

F R O N T P A N E L ( c o n t i n u e d )
No. Item
1 Indicators
2 Navigation Pad
3 Function Buttons
Jog/Shuttle
4
Controller
5 Power Switch
6 USB Ports

R E A R P A N E L
No. Item
1 Power Input
2 Audio I/O
3 RS-232
4 VGA Out
5 HDMI Out
6 Power Switch
7 LAN
8 USB
9 RS-485
10 Alarm In
11 Alarm Out
12 Grounding Screw
13 Network Interfaces w/PoE
14 eSATA
Description
• Power: GREEN when system has power and is turned on
• Ready: GREEN when system has booted up and is running properly
• Status: GREEN when DVR is controlled by IR remote,
by keyboard, ORANGE
• Alarm: RED when a sensor alarm is detected (not motion)
• HDD: BLINKS RED
when data is being read from or written to HDD
• TX/RX: GREEN
when connected to network,
network traffic
Moves cursor
Calls up various functions
Playback: Outer ring speeds up/slows down playback, dial advances/reverses
playback. Menus: Outer ring/dial moves selection up/down.
Turns unit on/off
Connects USB mouse or USB flash memory devices
Figure 2, DS-7716NI-I4/16P Rear Panel
Description
100 to 240 VAC
RCA connectors
Connects RS-232 devices
DB-15 connector for VGA output (display local video output and menu)
HDMI video output connector
Switch for turning device on/off
Connector for LAN (Local Area Network)
USB 3.0 port for additional devices
Connector for RS-485 devices. T+ and T- pins connect to R+ and R- pins of
PTZ receiver respectively.
D+, D- pin connects to Ta, Tb pin of controller. For cascading devices, the first
DVR's D+, D- pin should be connected with the D+, D- pin of the next DVR.
Alarm input connectors
Alarm output connectors
Ground (WARNING: needs to be connected when NVR starts up)
IP camera inputs and PoE outputs
Connects external SATA HDD, CD/DVD-RW
when IR remote and keyboard used at same time
BLINKS GREEN
RED when controlled
when there is