Wear Part Exchange - Beko DRYPOINT M eco control Installation And Operational Manual

Drying system
Table of Contents

Advertisement

EN

7.1.5. Wear part exchange

The device includes a solenoid valve and a piston valve whose seals are dynamically stressed; they are subject to wear and 
must therefore be exchanged cyclical.
The service life of these parts is many million switchings, however, it depends strongly on the actual runtime of the plant
and possibly also on the air contaminants.
The following values are listed as guide values for the preventive maintenance:
Single shift operation (260 work days/year) 
Continuous operation 24/7 
The normal wear at these parts - surface abrasion or deformations at the seat areas - has no impact on the function.
The full purge air volume flows continuously and the control function has no impact if the wear of the seals is too large or if 
the seals are destroyed, e.g. due to the impact of aggressive compressed air ingredients or significant ageing.
This system condition will not be detected by the device as a failure (red LED not illuminated) because the requirements for 
the set degree of drying are fulfilled. 
A required exchange of the wear parts during the warranty period does therefore not establish a warranty claim, but it
represents normal maintenance effort. 
Please contact the service of BEKO TECHNOLOGIES GmbH if maintenance cycles are required significantly more often for 
specific applications/installations.
Tools
Allen key Ø 2 mm
Allen key Ø 2.5 mm
with ≥ 100 mm shaft length
Allen keyØ 4 mm
with ≥ 100 mm shaft length
1.
De-pressurise device
2.
Disconnect device from electrical power
3.
Prepare workplace for the exchange of the wear parts.
NOTE
Damages possible
Damages of the device or the electronic printed circuit board as well as crushing or breakage of
cables can occur during the wear part exchange.
DRYPOINT
M eco control
®
average service life 1 year
Set of wear parts  4040729
Preparation of installation
While working, prevent the development of mechanical tensions, which can damage the
electronic printed circuit board or the cables.
average service life 2 years
Prerequisites
Material
Installation and operation manual
Protective equipment
None
35

Advertisement

Table of Contents
loading

Table of Contents