Installation and operation manual
Description
1. Unscrew the screws from the hood of the control unit
using an Allen key.
2. Open the hood of the control unit carefully to the back.
Route the ribbon cable to the left out of the cable run.
3. Bring the hood of the control unit into the displayed
maintenance position.
Use a screw of the control unit cover to secure it against
tilting and sliding.
4. Loosen the fixing screws towards the head of the
membrane dryer using an Allen key.
36
Figure
Ø = 2 mm
M = 0,6 Nm + 10 %
Ø = 4 mm
M = 2,5 Nm + 0,5 %
DRYPOINT
M eco control
®
EN