Installing The Lobby Station - Panasonic VL-VM701 Installation And Operating Instructions Manual

4.3 Installing the lobby station

Required items
– Module parts kit (sold separately) with lobby station
assembly
– Back box parts kit (sold separately)
– Surface mount cover parts kit (sold separately)
– Extension cable (sold separately) used to connect 2
frames of a lobby station together
– Wires that connect the lobby station to the electric
lock, and K-IN connection device (example: access
controller and/or open door sensor, etc.)
See "4.6.2 Wire type and maximum wire length
(Page 39)".
*1 A surface mount cover is required when the lobby
station is surface mounted.
Installation location
R Do not install the product in the following locations.
There may be a risk of malfunction or communication
disturbances.
– Places where vibration, impact, or echoing
occurs.
– Places near a high concentration of dust,
hydrogen sulphide, ammonia, sulphur, or noxious
fumes.
– Places where there is excessive smoke, dust,
and high temperature.
– Places exposed to direct sunlight.
– Places where most of the background is the sky.
– Places where the background is a white wall, and
direct sunlight will reflect off it.
– Near ocean coasts, where sea breezes will
contact the product directly, or near sulphuric hot
springs (exposure to salt can reduce the
product's life expectancy).
R Install the product away from electronic appliances
such as TVs, radios, personal computers, air
conditioners, boiler control panels with intercom,
home security equipment, wireless devices, or digital
cordless phones.
R Dust protection/water protection is IP55. Only when
installation work specified in this document is
properly performed and appropriate water protection
treatment is performed.
R Make sure the rear of the product is not subject to
water.
R Depending on the installation location, condensation
may form on the product's lens cover. This may
cause images to become obscured. Condensation
will dissipate as the temperature rises.
4.3.1 Installation position of the lobby station
and camera range
Refer to the following examples and confirm the area
viewable by the camera. In each illustration, the viewable
area is indicated by "A" and the centre of the camera
lens is indicated by "B".
*1
Side view
Camera height: 1500 mm
Camera lens angle: 0°
Approx. 110°
Approx. 1500 mm
Top view
Note:
R The measurements and angles shown here are for
reference purposes and may vary depending on the
environment.
R Install the lobby station so that the lobby station is not
exposed to strong light. If strong light shines on the
lobby station, the visitor's face may not be
distinguishable.
4. Installation
A
Approx. 2150 mm
B
Approx. 1400 mm
Approx. 500 mm
Approx. 750 mm
Approx. 500 mm
Approx. 170°
25