Panasonic VL-VM701 Installation And Operating Instructions Manual page 32

4. Installation
4.3.9 Connecting the wires
Important:
R Make sure you turn off the power to all devices at
the breaker before performing any wiring work.
Failure to observe this may cause product failure.
1
Remove the terminal cover from the camera module.
2
Strip the wires from all devices as below.
7 mm
3
Insert the wires from the power supply unit into the
DC terminal block, tighten the terminal block screws,
and then attach the terminal block to the DC
connection terminals.
R Connect the wires as follows.
DC IN: Power supply unit
4
Insert the wires from the electric lock into the 3-pin
terminal block, tighten the terminal block screws, and
then attach the 3-pin terminal block to the K-OUT
connection terminals.
R Connect the wires according to the specifications
of the electric lock. Only 2 wire connections are
needed.
NC and COM: For normally-open circuit type
electric locks
COM and NO: For normally-closed circuit type
electric locks
5
Insert the wires from the K-IN connection devices into
the 6-pin terminal block, tighten the terminal block
screws, and then attach the terminal block to the
K-IN connection terminals.
R Connect the wires as follows.
K-IN 1 C1 and C2/K-IN 2 C1 and C2:
K-IN connection device (example: access
controller and/or open door sensor, etc.)
32
Camera module
E
A B C
A Wires from electric lock
B Wires from access controller
C Wires from open door sensor
D DC wires from power supply unit
E 3-pin terminal block
F 6-pin terminal block
G DC terminal block
6
When using star wiring:
Insert the wires from the main monitor into the 2-pin
terminal block, tighten the terminal block screws, and
then attach the terminal block to the line connection
terminals.
R Connect the wires from the main monitor.
R When using star wiring, skip to step 8.
Example: 4-button module
A
A
A 2-pin terminal block
B Wires from main monitor (star wiring)
G
F
7 mm
D
7 mm
A
B A
7 mm