Panasonic VL-VM701 Installation And Operating Instructions Manual page 26

4. Installation
4.3.2 Assembling lobby station modules
The lobby station is composed of a combination of
modules according to the number of rooms connected
to.
– See page 6 for information on the composition of
each module.
– See page 10 for information on the items included
with each module.
Example: lobby station for camera module ´ 1 pcs. +
button module ´ 3 pcs. + blank panel ´ 1 pcs.
1
Attach each module (B) to the frame (A) as shown
below.
R Starting from the camera module, attach each
module in order from the top. (B-1—B-5)
R Insert the holders (
both sides of the frame.
R The combination of modules changes according
to the number of rooms connected to.
B B - 1
B - 2
B - 3
B - 4
B - 5
2
Hold down the left and right side plates (C), secure
them using the screws (D). Make sure that each
module is securely attached.
R The included number of screws differs according
to the back box type (large or small) connected
to.
D C
26
) into the slots ( ) on the
1 2
1
2
A
D C
4.3.3 Connecting flat cables
1
Remove each terminal cover (A) from each module
(A-1).
R Remove the terminal cover of the attached
module.
2
Connect the flat cable (B) from the camera module
to the module of the next button.
R Starting from the camera module, attach each
module in order from the top.
3
Connect the flat cables (B) to all of the remaining
modules.
4
After connections are completed, reattach each
terminal cover (A) to each terminal (A-2). Make sure
each module is securely attached.
R C: 1 of the included flat cables will not be used
Example: lobby station for camera module ´ 1 pcs. +
button module ´ 3 pcs. + blank panel ´ 1 pcs.
A
A - 1
A - 2
A
B
B
B
B
C