Installing The Lobby Station - Panasonic VL-V591 Installation And Operation Manual

Installing the lobby station

Installing the power supply unit on the wall
A DC cable is not included. You need to prepare one. Refer to "Wire type and distance" (page 11).
About the installation location
L T he AC cable plug is used as the main disconnect device.
Ensure that the power outlet is installed near the product
and is easily accessible.
L A readily accessible disconnect device shall be
incorporated external to the equipment.
– External disconnect device must be certified and have a
creepage and clearance distance of 3 mm or more.
Precautions for wiring
L M ake sure that the power supply unit is unplugged before
performing any wiring work.
L A lways connect AC or DC cables to the appropriate
connector or connection terminal.
L T o prevent the DC cable from disconnecting and to prevent
electric shock, secure the DC cable using the cable binder
(accessory) and attach the cable cover.
How to connect the AC cable and DC cable:
Connect the power supply unit (accessory), the AC cable
(accessory), and a DC cable (locally procured).
A
B
Power Supply Unit (VL-PS241) side: 1 25 mm 2 7 mm
Lobby Station (VL-V591) side: 1 52 mm or more 2 12 mm
Front view
F
G H
D C
*1 Make sure that there are no bare wires exposed outside
the product.
Installing the flush mounted box in the wall
Drilling dimension of wall surface for the flush mounted box
(Pitch of fixing screw)
148 mm
136 mm
162 mm
E
*1
<Side view>
80 mm
Power supply unit (with cable cover removed)
Top view
K
I
k DC cable binder hole
1
S trip the DC cables as follows:

DC cable (1, 2)
2
R emove the screws (3) and then remove the cable

cover (4).
3
C onnect the AC cable (5) (accessory) to the AC IN

connector (9) on the top of the power supply unit. Next,
connect the DC cable (7) (locally procured) to the DC
OUT terminal (j) on the bottom of the power supply
unit, and then secure the wires by tightening the screws
(6).
L R ecommended torque: 0.45 N·m {4.6 kgf·cm}
CAUTION
Insert the cables firmly all the way into the
connector and terminals. If the cables are not
inserted all the way, heat may be generated.
4
U se the cable binder (8) (accessory) to secure the DC

cable (7) (double-coated area) to the power supply
unit.
5
M ake sure to replace the cable cover (4).

Wall mounting
Attach the power supply unit to the wall securely.
1 Screws (accessory) x 2
A
Open the knockout holes of the flush mounted box, and
put the wires from each room and the door opener, and the
DC cable from the power supply unit through the holes.
Mount the box in the wall.
Knockout holes
Installation
Bottom view
J
Wires connected to
rooms and the door
opener
DC cable connected to
the power supply unit
Wall
7