Verifying Your Configuration; Configuring Transactional Rule Matching Feature - Cisco ASR 5000 Series Administration Manual

Enhanced Charging Service Configuration
Notes:
 In a timeslot if only the time is specified, that timeslot will be applicable for all days.
 If for a timeslot, "start time" > "end time", that rule will span the midnight. I.e. that rule is considered to be
active from the current day till the next day.
 If for a timeslot, "start day" > "end day", that rule will span over the current week till the end day in the next
week.
 In the following cases a rule will be active all the time:
 A timedef is not configured in an action priority
 A timedef is configured in an action priority, but the named timedef is not defined
 A timedef is defined but with no timeslots

Verifying your Configuration

To verify your configuration, in the Exec Mode, enter the following command:
show active-charging timedef name <timedef_name>

Configuring Transactional Rule Matching Feature

To enable the Transactional Rule Matching (TRM) feature, use the following configuration:
Important:
configure
active-charging service <ecs_service_name>
rulebase <rulebase_name>
transactional-rule-matching
end
Notes:
 Use the
no transactional-rule-matching
command to disable transactional rule matching.
 Transactional rule matching is disabled by default.
Important:
and will be governed by only the
independently can no longer be used to turn on or turn off this functionality.
To verify your configuration, in the Exec mode, enter the following command:
show active-charging rulebase name <rulebase_name>
The TRM feature is supported in SSI platform; earlier it was restricted only to ASR5500.
From 16.0 release, Transactional Rule Matching and Fastpath functionalities have been merged,
transactional-rule-matching
command or
default transactional-rule-matching
keyword alone. The keyword
Cisco ASR 5x00 Enhanced Charging Services Administration Guide ▄
Configuring Enhanced Features ▀
fastpath
115