Perform The Appliance Search; Bluetooth Communication; Setting Up The Bluetooth Connection - Truma iNet Box Operating Instructions Manual

For the remote control to function properly with SMS, it is
necessary for the standard SMS app of your mobile ter-
minal device to have your phone number as the sender and
not manipulate the text. Under no circumstances may "Web-
SMS connectors" be used.

Perform the appliance search

Preparation:
1. Connect all suitable iNet-capable appliances to
the Truma iNet Box and to the control panel (see
" Truma iNet Box" installation instructions).
2. Switch on the power supply for all connected appliances.
3. Perform the appliance search depending on the
Truma iNet Box interfaces used.
Appliance search, TIN1 interface:
All appliances are automatically recognised.
The iNet-capable appliances connected to the Truma CP plus
control panel must be known to the Truma CP plus control
panel. If this is not the case, you must perform the following
steps on the Truma CP plus:
Start the search of the appliances under menu item
"Service menu" -> "RESET" -> "PR SET".
After confirmation, the Truma CP plus control panel initialises
itself. "INIT .." appears on the display while this is in progress.
This stores in the Truma CP plus control panel the appliances
that have been found.
Observe the manufacturer's installation and operating in-
structions in the case of control panels from third-party
suppliers.
Appliance search, TIN2 interface:
Open the appliance manager in the Truma App under "Set-
tings" and perform the appliance search.
Resetting the Truma iNet Box to the factory settings also
enables an appliance search to be performed (see "Factory
setting" on page 11).

Bluetooth communication

Setting up the Bluetooth connection

To connect the mobile terminal device to the Truma iNet Box
for the first time, the mobile terminal device must be switched
on and Bluetooth must be activated (see the operating in-
structions of the mobile terminal device).
– Start the Truma App and open the remote control
– Press the button (Figure 2 – 1) on the Truma iNet Box for
approx. 1 second.
If a Bluetooth connection has already been set up, the
one under "Settings" -> "Set up Truma iNet Box" can be
changed.
If the Bluetooth pairing is active, the Truma iNet Box be-
comes visible for up to 2 minutes in the mobile terminal
device and the blue LED flashes at the same time (Figure 1).
The name "iNet Box" appears on the mobile terminal device.
The Bluetooth connection to the mobile terminal device can
be made.
Confirm the "iNet Box" connection in the Bluetooth settings
of your mobile terminal device.
5