Factory Setting; Cleaning And Maintenance; Repair; Firmware Update - Truma iNet Box Operating Instructions Manual

Factory setting

Resetting to the factory settings deletes all the data.
Reset all settings to the factory setting and delete all individu-
al data or for a appliance search on the interface TIN2.
Press the button (Figure 2 – 1) for at least 20 seconds.
The blue LED lighting up briefly indicates that the reset has
been completed and the appliance search on TIN2 has been
performed.
The Bluetooth connection to the Truma iNet Box must then
be deleted and restored in the settings of the mobile terminal
device.

Cleaning and maintenance

Clean the appliance only with a slightly moistened, lint-free cloth.
Do not use any chemical or scouring cleaning agents.
Make sure that no liquids or other components enter the
Truma iNet Box.

Repair

If repairs are necessary, contact Truma Service.
Following a repair / retrofit, the appliance search must
be repeated on the Truma iNet Box and with the
Truma CP plus control panel.

Firmware update

To perform an update, only one mobile terminal device may
be actively connected to the Truma iNet Box.
An available firmware update for the Truma iNet Box is indi-
cated as a notification in the Truma App.
The updates can be installed under "Settings" ->
"Truma iNet Box Update". Transmission is via Bluetooth (fol-
low the instructions in the Truma App).
The battery of the mobile terminal device must be sufficiently
charged before a firmware update.
The mobile terminal device should not be moved or used dur-
ing an update.

Disposal

The appliance must be disposed of in accordance with the ad-
ministrative regulations of the respective country in which it is
used. National regulations and laws (in Germany, for example,
the End-of-life Vehicle Regulation) must be observed.

Accessories

TIN bus cable, 3 different lengths
12 / 24 V connector cable
Fuse holder with 1 A fuse
TIN divider
11