Alerting Tones; Powering On/Off The Bluetooth Cordless Handset - Mitel MiVoice 6940 User Manual

Mitel MiVoice 6940 IP Phone User Guide
LED color, states, and indicator descriptions are as follows:
LED Color
Blue
(Handset Not
in Cradle)
Green
(Handset in
Cradle)
Notes:
1. Blinking denotes the LED is alternating very quickly between on and off.
2. Winking denotes the LED is alternating between being on for a short period of time and then
off for a longer period of time.
3. Fading denotes the LED is alternating between fading in and out.

Alerting tones

The handset provides the following alerting tones:
Event
Power OFF
Mute key on handset ON

Powering on/off the Bluetooth cordless handset

To power on the Bluetooth cordless handset place the handset on the IP phone's cradle.
To power off the Bluetooth cordless handset, press the Hookswitch key for approximately six
seconds until the LED indicator turns blue and then turns completely off.
126
LED State Indicates
Blinking Handset is not connected and is in pairing mode.
Winking Handset is connected but not in use.
Fading Handset is connected and in use.
Solid Battery is fully charged.
Winking Battery is charging.
Note: It is normal for the handset LED to cycle between winking and solid
as battery charge is maintained.
Off When handset is cradled and the LED does not flash or illuminate, this
indicates an absence of battery power. During the first 30 – 60 minutes that
the light is off, the battery may be trickle charging. If that is the case, the
LED will resume normal behavior within that 60 minute period. If the LED
remains off for more than 60 minutes, then either the battery is no longer
chargeable or there is a problem in the charging circuit.
Tone
Four tones successively decreasing in pitch.
Two low pitched tones