Isolate the electrical and water
1
supplies.
Disconnect and remove the old
2
shower from the wall.
Remove the cover and service
3
tunnels from the Mira Jump.
Keep the retaining screws (x3)
for later use.
Position the Mira Jump shower
4
on the existing pipework. Adjust
the shower inlet for water supply
pipe position if required. Do not
connect shower to pipe.
The case has thinned sections
5
that can be removed to allow
entry of the electrical cables.
Remove either of the top thinned
sections of the case for a falling
supply.
Feed the electrical cable in
6
through the back of the shower
and make sure the wires will
connect adequately to the
terminal block.
Retaining
Screw
BELOW
11
Retaining Screws
Service
Tunnel
REAR
SIDE
Cover