Mira Jump 96Va Installation And User Manual page 14

Connecting Electricity and Water Supplies
Flush the inlet water pipe through
1
to clear any debris.
Connect the inlet supply pipe to the
2
shower inlet using a 1/2" BSP nipple
with compression nuts and olives
(as shown) or a push-fit connector.
Fix the shower to the wall with
3
appropriate screws.
If the water inlet is rear fed, make
4
sure the elbow fitting can be
Removed for filter maintenance
post installation. (see section
"Maintenance - Cleaning the
Inlet Filter".)
Strip a short section of the electrical
5
cables if required. Fit an earth
sleeve to the earth wire if required.
Caution! Make sure the bare wire
ends are completely dry before
connecting to the terminal block.
Loosen the screws in the terminal
6
block and insert the bare wires into
the clamps:
L (Live) = Brown Wire
7
(Earth) = Green Sleeved Wire
N (Neutral) = Blue Wire
Note! Do not twist the cores of the
wires or strain the cables to make
them reach the terminal block.
Tighten the screws in the terminal
8
block so that they securely clamp
the bare wires.
14
Inlet Connector
Compression Nut
Olive
1/2'' BSP Nipple
Olive
Compression Nut
Inlet Supply