Mira Jump 96Va Installation And User Manual page 24

WARNING
There are no user serviceable parts inside the shower.
Servicing of the shower must only be carried out by qualified, competent
personnel following the instructions provided in this guide and those provided
with any spare part.
Before replacing any parts, ensure that the underlying cause of the malfunction
has been resolved.
Cleaning the Inlet Filter
Warning! Make sure that the electrical
supply is turned off at the mains and the
appropriate circuit fuse is Removed. Turn
off inlet water supply.
1. Remove the three cover retaining
screws, the cover and the service
tunnel.
2. Remove the screws that hold the inlet
clamp bracket in position and Remove
the clamp bracket.
3. Remove the two screws shown at the
base of the tank.
4. Carefully pull the flow valve assembly
and the heater tank away from the
case. Make sure that you ease the
inlet connector off the supply pipe.
5. Remove the inlet connector complete
with 'O' seal. Use a suitable tool to
withdraw the filter. Clean or renew the
filter.
6. Refit the filter, make sure that the filter
is correctly orientated and pushed
fully home.
7. Refit the components in reverse
order.
SERVICING
24
'O' seal
Filter