Mira Jump 96Va Installation And User Manual page 19

Operating Instructions
Turn the shower on
1. Switch on the electrical supply at the
double pole switch. The power light is
illuminated.
2. Turn the shower on by pressing the
start/stop button.
Select heater setting
3. Turn the heater control to High. Allow
15-20 seconds for warm water to
reach the handset.
For electrical economy, set the
heater control to Eco. This setting
will provide sufficient power during
the summer when the mains water
temperature is warmer.
For a cold shower, set the heater
control to Low.
Caution! Always check the water
temperature before entering the
shower.
Adjust the showering temperature
4.
Adjust the shower temperature by
turning the temperature control as
necessary. Turn clockwise for hotter
water and anticlockwise for cooler
water. Allow 10-15 seconds for the
for the shower to fully adjust to the
required temperature.
Note! It is normal for the flow rate
(shower force) to change when the
temperature is changed.
To turn the shower off
5. Turn the shower off by pressing the
power button.
Note! A small amount of water may
continue to flow from the handset for
a few moments.
6. Switch off the electrical supply at the
double pole switch. The power light
turns off.
+
_
19