Configuring The Lora Packet Forwarder; Additional Lora And Mlinux Information - Multitech MultiConnect Conduit Getting Started Manual

GETTING STARTED WITH MLINUX MODELS

Configuring the LoRa Packet Forwarder

1. Log in to the console, if you are not logged in.
2. Establish an Internet connection via Ethernet or cellular.
3. Edit the packet forwarder configuration as necessary by modifying /opt/lora/global_conf.json (version
2.1) or /opt/lora/local_conf.json (version 1.5) with vi or nano.
gateway_conf["server_address"]
gateway_conf["serv_port_up"]
gateway_conf["serv_port_down"]
4. Start the packet forwarder:
$ /etc/init.d/lora-packet-forwarder start

Additional LoRa and mLinux Information

For additional information, including how to configure LoRa devices to communicate with the MTCDTIP, visit
http://www.multitech.net.
For help using LoRa, go to:
For help using mLinux, go to: http://www.multitech.net/developer/software/mlinux/.
For additional information regarding configuration, go
to:http://www.multitech.net/developer/software/lora/getting-started-with-lora-conduit-mlinux/
For additional packet forwarder information, go to:
http://www.multitech.net/developer/software/lora/conduit-mlinux-convert-to-basic-packet-forwarder/
12
http://www.multitech.net/developer/software/lora/
® TM
MultiConnect Conduit
Set your LoRa network server address
Set the up port used by your LoRa network server
Set the down port used by your LoRa network server
Base Station IP67 Getting Started Guide for Versions 1.5 and 2.1