Electrical connection
The following contains a short description of how to connect the sensor for operation with the
transmitter SITRANS FUS060. For more information, refer to the relevant Operating
Instructions of the transmitter.
Only qualified personnel may carry out work on the electrical connections.
Use in hazardous areas
Before opening the terminal box check that:
No explosion hazard exists
A fire department permission certificate has been issued
All connection leads are potential free
Special requirements apply to the location and interconnection of sensor and transmitter.
See "Installation in hazardous area" (Page 10)
5.1
Step 1: Transducer wiring
Electrical connection of transducer
1. Remove the lid of the terminal housing
2. Connect the wire without a spade terminal to
3. Connect the wire with a spade terminal to
SITRANS F US SONO 3100
Operating Instructions, 03/2011, A5E00814513-06
WARNING
WARNING
Transducer cut-away
②
③
(the transducer housing).
5
23