Pro-Ject Audio Systems Signature 12 Instructions For Use Manual page 5

1. Platter assembly
Before platter (1) assembly, unscrew three transport screws.
Remove protective covers from shaft and platter bearing.
Check for adequate lubrication of the shaft (2).
If necessary, lubricate with grease in the attached accessories.
WARNING: The platter is floating on magnets.
When putting on the shaft, take care not to damage the magnet.
2. Idler pulley assembly
Idler pulley consists of two parts. One is powered by the motor units and one is floated on the magnetic
cushion. Both parts form a whole stored on a common shaft. Before installing this kit remove the covers from
the shaft and bearing. Check for adequate lubrication. If necessary, lubricate with grease in the attached
accessories.
3. Drive belt assembly
Drive belts (4) fitting in order:
Drive belt (7)
WARNING: Don't stretch belts too much to avoid damage.
4. Headshell
Headshell is stored in a separated packaging.
When assembling, follow instructions:
a) Mounting the cartridge into the headshell:
front drive - idler pulley (3)
rear drive - idler pulley (3)
idler pulley (3) - platter (1)
© Pro-Ject Audio Systems · Pro-Ject Signature 12 · Revision 2014.11.04
5