Pro-Ject Audio Systems Signature 12 Instructions For Use Manual page 15

Table of Contents

Touching on field 33 or 45 selects the desired speed. The display shows „WAIT" .

After reaching rated speed is displayed selected value 33,3 or 45,1 .

Rated speed can be correct by touching the + or –, which changes the value by 0.1 %

Turn off or pause the recording, touch STOP.

Please note :

The actual shown speed must not be as the speed in reality. A lot of different possible physical variations may

influence it. For correct control of turntable speed is supplied Pro-Ject Strobe it

Determining the correct spinning speed of a turntable with Strobe it:

Strobe it shows circularly arranged dashes that are assigned to speed and frequency. Please remember the

ring that matches speed and frequency (33 1/3 rpm with 50 Hz and 45 rpm with 50 Hz are valid for

Europe).

Put Strobe it on the turntable platter and start the turntable. The tonearm remains in its initial

position.

Align a mains powered light source directly to the turntable with Strobe it rotating. The dashes of

previously pinned ring should now give the impression to stand still. If

backward, the speed is either too high or too low.

Note:

Use normal mains-operated lamps.

and

LEDs, which are operated with direct current are not suitable.

Time and date setting

Daylight,

fluorescent lamps (energy saving lamps) as well as flashlights

they

seem to move slightly forward or

Table of Contents