Pro-Ject Audio Systems Signature 12 Instructions For Use Manual page 9

Assembly of anti-skating is described in the following four steps:
Step 1: Mounting the thread on the hook screw
Step 2: Put the thread on the correct position in the tonearm groove
Step 3: Mounting the anti-skating sliding mechanism on the shaft
Step 4: Positioning of the sliding mechanism. Eye of the thread insert on the pin in the groove.
When the tonearm is over the first outer groove of the record, the anti-skating thread must be already
tensioned, when it's in the end, it must be still on tension.
WARNING: When the thread isn't tensioned at the beginning, at the end already falling on the other side.
Be careful, there is a danger to rip off thread by tensile force.
9
© Pro-Ject Audio Systems · Pro-Ject Signature 12 · Revision 2014.11.04