Alert Codes - Somnetics Transcend Auto User Manual

Transcend Auto User Manual
Device Fault
LED LED
Off Flashes
13
times*
Off Flashes
14
times*
* If this fault occurs, check all tubes and hoses to ensure that they are properly connected. If the fault
occurred during therapy, make sure the mask is properly fitted and not leaking. Check that all filters are
properly installed and not excessively dirty.

Alert codes

Alerts are similar to faults but they do not reset the processor when they occur (i.e., the Auto
device continues to deliver therapy pressure).
Device Fault
LED LED
Off Flashes
15 times
Error Comments
Processor over- The processor on-chip temperature sensor has reported an
temp excessive temperature.
Blower over- The blower thermistor has reported an excessive temperature.
temp
Error Comments
Cannot regulate Device repeatedly detected the monitored pressure outside of
the therapy target range. The device attempts to continue to
deliver therapy. The alert is an indication that filters and the
mask should be inspected for cleanliness and proper fit.
Page 31