Using The Ezex Function; Ending Therapy; Drying Mode - Somnetics Transcend Auto User Manual

Transcend Auto User Manual

Using the EZEX function

The EZEX function is a special feature that decreases therapy pressure on exhalation.
This feature is designed to provide additional comfort to the patient by reducing the
amount of resistance they experience as they exhale. EZEX settings are adjusted by
clinicians only.
There are four EZEX settings: OFF, 1, 2 or 3; progressively increasing the amount of
pressure relief from none to maximum.

Ending therapy

To end the delivery of therapy while the blower is on, press the Power button to
deactivate the blower and return the device to Standby Mode. It is recommended the
user initiate the Drying Mode function after each therapy session to dry the device
interior.

Drying mode

At the end of each therapy session it is recommended the user initiates the Drying Mode.
To initiate Drying Mode depress the Ramp button and press the Power button
simultaneously. When in Drying Mode the blower runs at a low speed for 30 minutes.
During Drying Mode the LED lights remain off and blower pressure is not regulated to
provide therapy. Using the Drying Mode flushes air through the system to remove traces
of moisture from the interior of the device and airway circuit. After the 30-minute drying
cycle, the blower will turn off and the device will automatically enter Standby Mode.
Ramp button
Power button
Page 24