Devatec ElectroVap ELMC 1 SM CYL Technical Manual page 48

Configuration changing menu
ADJUST STEAM BY
− − − − − − − − − − − − − − −
CYLINDER SELECT
− − − − − − − − − − − − − − −
IDENTIFICATION
OF ELMC − −
SPEED DATA
SETTING TEMP
WATER 65°C : − − −
DRAINING AFTER
SHUT DOWN?
DRAINING AFTER
− − − HRS
If end of the year drainin
g has been enabled
HOME MENU
IMPORTANT NOTICE
The units have a factory default maintenance time of 300 hours that suits to most cases. The exact
maintenance frequency is variable and depends on water quality, hours of run and level of demand for
humidification. New installations should be inspected or serviced frequently to enable a suitable
maintenance routine to be established.
For hard or very hard waters, the use of a cleanable cylinder is recommended.
A cleanable cylinder maintenance guide can be found on the next page. This should be seen as an help
only and not be considered as a binding information from devatec in any case.
E
LECTRO
System management
9600 b/s
− − −
V MC2
AP
Possible value : evaporation or draining
Possible value :
DISPOSABLE (EV), DISPOSABLE (EA),
DISPOSABLE (ED), CLEANABLE (EV),
CLEANABLE (EA), CLEANABLE(ED)
Possible value : between 1 & 32
Possible value :
Between 1200, 2400, 4800 and 9600 b/s
Possible value : YES or NO
Possible value : YES or NO
Possible value : between 1 and 168 H
48 Pictures for illustrating purposes only