Devatec ElectroVap ELMC 1 SM CYL Technical Manual page 19

INSTALLATION
For ensuring the best steam distribution possible, we would recommend to install the steam
pipes in either diameter as per the two methods described underneath.
How to install on a duct (particular)
Your steam pipes must be screwed
onto the ventilation duct by the
fixing plate with a set of 4 bolts and
nuts of Ø 5 mm.
The length of the bolts will be
according to the thickness of the
ventilation duct.
How to attach the pipe end ( inside the duct ) - Particular
The end of the steam pipe should be attached to the duct with a threaded rod of Ø 5 mm
going from the dedicated hole of the fixing plate to the outside of the duct and attached
by a couple of nuts (method 1). A rail attached to the inner side of the duct can also be
used - a 5mm bolt and nut are used to settle the pipe on the rail (method 2).
Method 1
E V
LECTRO
Installation - Step 3
Threaded rod
The steam pipe must be at
level with the duct.
19
MC2
AP
84
100
Method 2
Rail
8
Pictures for illustrating purposes only