2 CONNECT OPTIONAL DEVICES
2. Insert the tweezers into the screw hole and then lift the
cover.
3. Peel off of the tape cover of the Cushion (G13-1992-
x4) on the component side of the VGS-1.
4. Insert the VGS-1 connector (CN1) into the connector
(CN403) on the TX-RX PCB (B/1).
28
5. Peel off the tape cover of the Spacer (J30-1292-x4),
and attach it to the space as illustrated.
6. Reinstall the cover and battery pack.
2.7.9 Install VGS-1 to TK-7180/ 8180
1. Remove the chassis of the TK-7180/ 8180
transceivers.
•
Pull and lift the top cover by widening two side
tabs. Then, pull upward to separate the top cover
from the transceiver body.
•
Remove the top rubber packing.
•
Remove 4 screws and then lift the shielding plate.
2. Insert the VGS-1 connector (CN1) into the connector
(CN403) on the TX-RX PCB (B/3).
Modification Information
Version: 1.13 USA