Install Kds-100; Configuration Using Kpg-89D - Kenwood TK-2180 Modification Information

2 CONNECT OPTIONAL DEVICES

2.3.7 Install KDS-100

1. Connect the KCT-40 cable to the transceiver.
(Refer to 2.2.8 Connecting KCT-40 Cable.)
2. Connect the KCT-40 cable to the KDS-100.
3. Turn the transceiver ON.
The KDS-100 is also automatically turned ON.

2.3.8 Configuration using KPG-89D

1. Run the KPG-89D.
2. Select
"Program > Read Data from the Transceiver"
You can also click the
The Read Data from the Transceiver window appears.
3. Click "Read".
The KPG-89D starts reading the configuration data
from the transceiver.
The Extended Function window appears.
4. Select
"Edit" > "Extended Function"
5. Click the AUX tab.
6. Select "KDS-100" from the External Device pulldown
menu.The necessary functions for the KDS-100 are
14
.
icon on the Toolbar.
.
Modification Information
automatically assigned to each port.
7. Select COM setting to "Data" for COM port 2.
"Edit>Oprional Feature>Common-Page 3 Tab"
8. Select PC Interface protocol to "Ver.2".
"Edit>FleetSync>>General 1 Tab"
9. Configure to be enable each serial Output for Status
Message/Short Message/Unit ID serial Output.
"Edit>FleetSync>>General 2 Tab"
10. Select
"Program" > "Write Data to the Transceiver"
The Write Data to the Transceiver window appears.
11. Click "Write".
The configuration data is written to the transceiver.
Note:
To use KDS-100 with PC2 Protocol (Ver2), the above setting
is neccessary. KENWOOD recomend PC2 Protocol for KDS-
100 connection. By using PC2 Protocol, Radio remote
feature will be available. To use the current PC protocol
(Ver1) for connect KDS-100, skip the process 8.
And you can configure AUX input ports (pin 12,13,21) to
other functions if select PC mode connection.
To use KDS-100 under Air mode, skip process 1,8,9. For
using Air mode, configure deffuerent FleetSync ID to Radio
and KDS-100.
.
Version: 1.13 USA