Kenwood TK-2180 Modification Information page 24

2 CONNECT OPTIONAL DEVICES
• Lock the cover.
• Insert the cable into the connector of the
transceiver as shown on the figure.
CAUTION
MAKE SURE THAT THE METAL CONTACTS OF FLAT
CABLE ARE FACING DOWNWARD WHEN THE FLAT
CABLE IS INSERTED INTO THE CONNECTOR.
5. Install the KRK-10 blank panel (A62-1101-x1) to the
transceiver.Install the panel by hooking two tabs to the
panel.
CAUTION
YOU MUST KEEP THE FLAT CABLE AWAY FROM THE
MAIN PANEL WHEN INSTALLING THE MAIN PANEL TO
THE FRONT OF THE CHASSIS .
6. Insert the flat cable on the interface board (B/2) of the
KRK-10 rear panel (A82-0056-x1) and insert the cable
into the connector (CN902) on the display board.
• Lift the connector cover and insert the flat cable
into the connector as shown in the figure.
20
• Insert the connector cover and install the flat cable.
CAUTION
MAKE SURE THAT THE METAL CONTACTS OF FLAT
CABLE ARE FACING DOWNWARD WHEN THE FLAT
CABLE IS INSERTED INTO THE CONNECTOR.
Note: The flat cable is plugged into the connector as a factory
default setting.
7. Install the panel by engaging two tabs on the rear
panel.
Modification Information Version: 1.13 USA