Kenwood TK-2180 Modification Information page 49

3 CONNECT THIRD PARTY OPTIONS
5. "Edit > FleetSync > GPS Tab".
Configure GPS Information on this screen.
Refer to the "FPRG 7.6 6.7.3 Common-Page 3 Tab" for
details.
5.1 Configure Base station ID for sending GPS data.
5.2 Select GPS report mode
[Auto].....GPS data report automatically to the
Base station every often configured following
interval.
[Poll].....GPS data is report when radio receive a
GPS sending request from Base station. Radio
send GPS data for configured times with
configured interval.
5.3 Configure GPS time mark. It is a offset
configuration for GPS sending, based on UTC. If
you are using several vehicle in same fleet, it can
avoid the data transmitting collision. Each radio
should be assigned different number.
5.4 Select GPS Message type. it does not need to
change. But, to select "Short", you might save a air
time to send GPS data.
[Full].....The current message type same as TK-
*80. Its data format includes $GPGGL, $GPRMC
and $GPGLL. (500ms/message)
[Short].....This GPS message type can save the
air time. It includes $GPGLL only. If base station
select $GPGGL and $GPRMC as serial output
data, some part of data will be blank.
45
6. Configure GPS Report Interval Time. It is used for
GPS auto report and report GPS data when receive
GPS data request message from Base station.
7. Configure GPS combination such as PTT ID + GPS,
Status message + GPS or Emergency Status + GPS if
you need.
8. Select
You can also click the
Write Data to the Transceiver window appears.
9. Click "Write".
The configuration data having the GPS information
will be written to the transceiver.
Modification Information
"Program" > "Write Data to the Transceiver"
icon on the Toolbar.The
.
Version: 1.13 USA