2 CONNECT OPTIONAL DEVICES
2.6.7 Install KAP-2
1. Remove the chassis of the TK-7180/ 8180
transceivers.
•
Lift the top cover by widening two side tabs, using
a flat-head screw driver etc. Then, pull upward to
remove the top cover from the transceiver body.
•
Remove the top rubber packing.
•
Remove 4 screws and then lift the shielding plate.
2. Push the cap on the rear panel of the chassis from the
inside of the chassis.
24
3. Insert the 6-pin connector of the connection cable .
4. Insert the bushing part into the chassis hole fully .
5. Turn the bushing part of the connection cable
clockwise 90 degrees as seen from the inside of the
chassis.
Modification Information
Version: 1.13 USA