Ani Board; Board - Kenwood TK-2180 Modification Information

3 CONNECT THIRD PARTY OPTIONS
3.2

ANI Board

You can install the ANI board to the transceiver. This
section describes how to install the CIMARRON QE-2 to
the transceiver.
Refer to the following URL for the information about the
ANI board (QE-2).
http://www.cimtechcorp.com/qe1manual.pdf
!
Items Required to Install
• Transceiver
• QE-2
• Adhesive Tape supplied with the QE-2.
• Cushion Tape
CAUTION
YOU MUST TURN THE TRANSCEIVER OFF AND REMOVE
THE POWER CABLE BEFORE CONNECTING THE OPTION
INTO THE TRANSCEIVER.
3.2.1 QE-2 Board
1. Unplug the QE-2 board from the connector if it is
attached.
2. Modify and configure the QE-2 board as follows.
• Suck and remove the soldering on K.
• Solder the position between G and A.
G
35
K
A
Modification Information
• Confirm that G, A, and P are soldered (bridged).
3. Configure each signal logic of optional board
according to following table.
(Refer to 1.2 26-pin Accessory Connector.)
Table 3-2 Terminal Description
Land Name I/O Board Function
OPT1 O Channel Busy
OPT3 I KEY
OPT4 O PTT
OPT5 O Emergency
OPT2 I Aux I/O
GND O V -
SB2
I V +
8C
STON O Sidetone
INH
I Aud Inhib
AUDIH
DI/A
O Data Out
DTI
OPT6 O Man-Down
TCNT
I ToneCtl
TCTL
Note: The radio Zone configuration includes Trunking or
mixed Trunking and conventional mode, "CH busy"
should be configured Transmit Mode as Trunking.
Otherwise, when the radio is used under
conventional mode only, "CH busy" should be
selected "Conventional" for Transmit Mode.
We have checked a radio working under following
condition of QE-2.
Transmit Option;
• Conventional Only
Transmit Mode=Conventional
Attack Delay=325ms
check "Busy when Hi"
• Trunking and Mix with some
Transmit Mode=Trunking
Trunk Select Debounce Time=200ms
check "Trunk Available when Low"
PTT Option; check "Key Follow PTT [TOT]".
These setting depend of your system. Please make sure
each timing and configuration consisted your System.
REMARKS
Busy H/ LOK L
Active L
Active L
Active L
Active L
-
7.5V typ
8.0V typ
1kHz 5Vpp
Active L
(Mic Mute)
600mVpp
STD
Active L
Active H
(Tone Sound)
Version: 1.13 USA