2.5.8 Install KRK-10
1. Remove the panel.
Lift the rear panel by widening two side tabs, using a
flat-head screw driver, or etc. Then, pull upward to
remove the rear panel from the transceiver body.
CAUTION
REMOVE THE PTANEL SLOWLY. OTHERWISE, THE FLAT
CABLE MAY BE DAMAGED.
2. Remove the flat cable.
•
Remove the cable from the connector on the PCB
board.
Version: 1.13 USA
•
Remove the cable from the panel.
3. Fold the flat cable along with the black lines (3 lines).
•
Fold the flat cable along with the diagonal black
line as shown on the Point 4.
•
Fold the flat cable along with the top black line as
shown on Point 5.
•
Fold the cable as shown on Point 6.
4. Insert the flat cable folded at the step 3 into the
connector.
•
Lift up the connector cover of the interface board
(A/2) of the KRK-10 main panel (A62-1101-x1) and
insert the cable into the connector as shown in the
figure.
Modification Information
2 CONNECT OPTIONAL DEVICES
19