Foot Switch; Install Foot Switch; Configuration Using Kpg-89D - Kenwood TK-2180 Modification Information

3 CONNECT THIRD PARTY OPTIONS
3.4

Foot Switch

(TK-7180/ 8180 only)
A general purpose foot switch can be connected to the
TK-7180/8180 transceivers.
Follow the instructions below to attach and install the foot
switch.

3.4.1 Install Foot Switch

1. Connect a cable from the foot switch to one of D-sub
25-pin male connector.
The pin 4, 8, 12, 13, 20, 21, 22, 23, and 24 are
available to adapt the foot switch.
To D-sub 25-pin
2. Plug the D-sub 25-pin male connector to the back of
the TK-7180/8180 transceivers.

3.4.2 Configuration using KPG-89D

After installation of the Foot Switch, the configuration data
for the Foot Switch must be written to the transceiver via
KPG-89D.
Following procedures is to configure the Foot Switch
information into the transceiver.
1. Run KPG-89D.
2. Select
"Program" > "Read Data from the Transceiver"
You can also click the
The Read Data from the Transceiver window appears.
3. Click "Read".
The KPG-89D starts reading the configuration data
from the TK-7180/ 8180 transceivers.
4. Select
"Edit" menu > "Extended Function"
The Extended Function window appears.
5. Click the AUX tab.
43
icon on the Toolbar.
.
Modification Information
6. Select "Input" from the I/O edit box for the pin that the
Foot Switch is installed, and
Function pull-down menu for the pin.
7. Select "Edit" > "Emergency Information".
The Emergency Information window appears
8. Configure the Emergency information.
Refer to "FPRG 6.14 Emergency Information Window"
for the details of configuration.
9. Select
"Program" > "Write Data to the Transceiver
can also click the
The Write Data to the Transceiver window appears.
10. Click "Write".
The configuration data having the Emergency
information will be written to the transceiver.
.
from the
"Emergency"
icon on the Toolbar.
Version: 1.13 USA
". You