3.5
External GPS Unit
(TK-7180/ 8180 only)
You can install the GPS receiver to the TK-7180/ 8180
transceivers. This section describes how to install the
Garmin GPS35-HVS to the TK-7180/ 8180 transceivers.
Refer to the following URL for the information about the
GPS receiver (GPS35-HVS).
http://www.garmin.com/products/gps35/
!
Required Items to Install
•
TK-7180/ 8180
•
GPS35-HVS
•
D-sub 25-pin Connector
3.5.1 Install GPS-35HVS
1. Connect the GPS35-HVS cable to the D-sub 25-pin
connector.
Following procedures shows how to connect the GPS
receiver.
14
1
Vin TXD1
GND
RS-232level
GPS Receiver
(Garmin GPS35-HVS)
Version: 1.13 USA
2. Connect the D-sub 25-pin connector to the TK-7180/
8180 transceivers.
25
13
3.5.2 Configuration using KPG-89D
You can configure the GPS receiver information to the
transceiver via KPG-89D after installing the GPS unit.
Follow the procedures below to configure the GPS
receiver information into the transceiver.
1. Run the KPG-89D.
2. Select
You can also click the
The Read Data from the Transceiver window appears.
3. Click "Read".
The KPG-89D starts reading the configuration data
from the TK-7180/ 8180 transceivers.
4. Select "
.The Optional Features window appears.
Tab"
Configure the COM port to GPS.
Note: COM-1 can accept RS-232C level data. In case of GPS unit
has TTL level data output, use COM2. And there is a
capability to change polarity of data. If you install GPS-35
HVS (Garmin), it is not necessary to change it.
Modification Information
3 CONNECT THIRD PARTY OPTIONS
"Program" > "Read Data from the Transceiver"
icon on the Toolbar.
Edit" > "Optional Features > Common-Page 3
.
44