Table of Contents
Advertisement
3.1.2 Mounting the NextMove ESB
CAUTION: Before touching the unit be sure to discharge static electricity from your
Ensure you have read and understood the location requirements in section 3.1.1. Mount the
NextMove ESB using the supplied M4 screws. For effective cooling, the NextMove ESB must
be mounted on a smooth non-flammable vertical surface. Orientation must be as shown in
Figure 1, with the two slots in the metal carrier / heat sink assembly at the bottom.
Mounting keyhole and slot detail
A
B
There must be at least 20mm (0.8 in) clearance between the NextMove ESB and neighboring
equipment to allow sufficient cooling by natural convection. Remember to allow additional
space around the edges to accommodate the mating connectors and associated wiring. For
example, 70mm (2.8 in) clearance will be required for connection of the serial port cable.
3-2 Basic Installation
body and clothing by touching a grounded metal surface. Alternatively,
wear an earth strap while handling the unit.
All dimensions shown as
Drawings not to scale
A
C
Figure 1 - Package dimensions
245 (9.65)
170 (6.7)
mm (inches)
A 4.5mm
B 10mm
C 11mm
www.supportme.net
MN1924
Advertisement
Table of Contents
